The KORUS system was created with the aim to provide the surgeon with complete and reliable solutions for an increasingly personalized surgery.

–           135° and 125° CCD angle neck, mirror polished finishing and tapered geometry for increased ROM and decreased risk of impingement
–          Threaded extraction hole
–          Low trochanteric invasivity, easier insertion and reduced incision, especially with an anterior approach
–          Proximal trapezoid section resists axial torsional stresses and facilitates osseointegration
–          Vertical and horizontal grooves to increase the contact surface area and provide axial and rotational stability
–          Square section distal design provides rotational stability with no contact with the cortical
–          Step geometry converts torsional stresses into compressive loads
–          The stem is in compliance with European standards, having CERAMTEC approved 12/14 morse taper (5°42’30’’)

New
Skinny neck

• Better joint flexibility
• Increased ROM

Reduced neck length

• Shorter taper (- 2 mm)

Materials

Titanium alloy Ti 6Al 4V (ISO 5832-3)
Finishing: 150 μm HA OSPROVIT coating

Download the PDF
KORUS-IP-000 REV 03 2017
KORUS-OT-000 REV 00 2018